Installation Instructions

The Installation Process is Extremely Simple.
Within 20 minutes to 2 Hours, most suburban gardens can be Fully Protected.
Time varys with type of kit and size of garden.

Step 1

Plot and measure your garden. Determine where you would like the gate and place the point of the first stake on the ground. Slide the leveling guide over the stake and center the two level indicator bubbles. Place the stake driving tool on top of the stake and seat the grooves.  Hammer the stake driver and drive the stake into the ground. Check the leveling guide often and center bubbles to ensure straight stakes. Stop when the top of the stake is 6 inches above the top of the leveling guide.

Step 2

Repeat the Stake installation process for each post to encompass your garden. Place the posts no more than 12 feet apart to outline the perimeter.  After encircling the garden, a short "gate stake" will be placed next to the first stake and an additional stake will be placed 3 feet from the first post to provide gate access.

Step 3

Slide the posts over the stakes.  Push  the large end of the fence retaining clips into  the pre-drilled post holes. Roll out the fence fabric and snap the retaining clip around the fence fabric to secure it.  Continue to unroll the fence fabric, pull snug and secure with the retaining clips as you proceed around the garden.

Step 4

In as little as 20 minutes (Part # 500 Garden Fence Kit) an attractive, effective and durable garden enclosure is in place  to protect your plants from woodland and rural pests. Expensive landscaping plants, aromatic flowers, and your favorite garden veggies can now be protected without destroying your view, or the appearance of your property.